Parking Lot
ADA Parking Striping in Lebanon, Oregon: Bringing Your Lot Up to Code
Cojo
May 30, 2026
6 min read
A restripe is the most common moment a Lebanon lot gets brought up to code. Once the paint has faded and fresh lines are due anyway, correcting a non-compliant accessible layout costs little more than reproducing the wrong one. For Lebanon's Main Street retail and its busy medical-district lots, that is the right moment to get the accessible stalls right.
This guide covers what an ADA-compliant restripe looks like for a Linn County lot and what to verify before the first line goes down. It builds on our statewide Oregon ADA parking compliance guide.
A correct accessible stall is more than a blue box:
Two accessible stalls can share one access aisle. For full marking detail, see our 2026 ADA striping requirements and the ADA access aisle striping spec.
A restripe is the right moment to confirm your accessible count is current. The standard is one accessible space per 25 total, scaling up, with at least one in six accessible stalls being van-accessible. Lebanon's medical district makes count verification especially important: outpatient medical facilities require 10 percent of total spaces to be accessible, and rehab or physical therapy facilities require 20 percent. A clinic or therapy lot that was striped to the standard ratio is likely under-provisioned. Catch this during layout, before paint hits asphalt.
Striping makes a lot look compliant, but it cannot fix slope. The 2 percent maximum on accessible stalls and aisles applies to the finished surface. If settlement has pushed your accessible stalls past that limit, fresh paint over a 3 percent slope is still a violation. Before restriping, check the accessible stalls and aisles with a level. If slope exceeds the limit, regrade or patch first. Painting around it hides the problem from your eyes, not from a tape and level.
Western Oregon's wet season and summer UV fade traffic paint, and faded accessible markings become a compliance gap:
Traffic paint needs dry pavement above roughly 50°F to cure, which in Lebanon means late spring through early fall. Booking in spring for early-summer work usually secures better scheduling before the season fills.
A compliant restripe needs compliant signs. Each accessible stall requires a vertical sign with the International Symbol of Accessibility mounted at least 60 inches to the bottom, a "Van Accessible" plate on van stalls, and Oregon's required fine-amount plate. Replace bent, low, or faded signs as part of the same project rather than leaving a freshly striped lot with non-compliant signage.
If the whole Lebanon lot is due for fresh lines, fold the ADA corrections into the larger restripe to share mobilization costs. Pricing and seasonal timing are covered in our parking lot striping in Lebanon guide.
The dimensions and specs here are general guidance based on the 2010 ADA Standards and ORS 447.233. Your lot's exact compliance depends on measured conditions, so have a qualified contractor verify dimensions and slope before painting.
Understand what happens during an ADA parking compliance audit, common violations found in Oregon commercial lots, and how to prepare your property.
Complete guide to ADA parking requirements in Oregon, including space dimensions, van accessible standards, signage rules, and ORS 447.233 specifics for commercial property owners.
See real before-and-after results of commercial sealcoating projects in Oregon and learn how this affordable maintenance extends parking lot life by a decade or more.
Have a question about this topic? We'll respond within 24 hours.