ADA Parking Striping in La Grande, Oregon: Bringing Your Lot Up to Code

Restriping a La Grande Lot to ADA Layout

A restripe is the best chance a La Grande property owner gets to fix accessibility problems. Faded paint is the visible reason to repaint — and at 2,800 feet, with winter sand, plow blades, and high-valley UV, paint here wears fast — but underneath it many lots carry layout issues that have been there since the asphalt was first marked: too few accessible spaces, narrow aisles, missing van dimensions, or signage that never met Oregon's standard. Repainting over the same lines just preserves those problems.

This guide is for La Grande owners and managers who want the restripe done to current ADA layout, not merely restored to what was there before. For the statewide foundation, see our ADA parking compliance guide for Oregon.

Get the Stall Dimensions Right Before Paint Touches the Lot

ADA accessible stalls are not standard stalls painted blue. The dimensions are specific:

• Standard accessible stall: minimum 8 feet wide, with an adjacent access aisle at least 5 feet wide.
• Van-accessible stall: minimum 8 feet wide with an 8-foot access aisle, or 11 feet wide with a 5-foot aisle. The combined footprint runs 16 feet either way.
• Van count: at least 1 in every 6 accessible stalls must be van-accessible.

La Grande's downtown and campus-adjacent lots frequently restripe a row of accessible stalls without a single van-accessible space, or share a too-narrow aisle between two stalls. Before any paint goes down, the layout should be chalked and verified against the 2026 ADA striping requirements for Oregon. Because freeze-thaw heaves the surface, the chalk stage is also a good moment to confirm the chosen stalls still sit within the 2 percent slope limit.

Access Aisle Striping Is Where Most Lots Fail

The access aisle beside each accessible stall must be striped, not left blank. It needs diagonal hatching across its full length so drivers know not to park there, and many jurisdictions expect "NO PARKING" lettering inside the aisle. The aisle must sit level with the stall and connect to a marked accessible route to the entrance.

When two accessible stalls share one aisle, that shared aisle must still meet the full width requirement. Our ADA access aisle striping spec covers hatch spacing, lettering, and shared-aisle rules.

The Accessibility Symbol and Signage

Each accessible stall gets the International Symbol of Accessibility painted on the pavement, typically white on a blue field, in the correct proportion and orientation. A freehand or undersized symbol invites a complaint. In La Grande, durable paint or thermoplastic is often worth the upcharge because winter sand and plow blades scrape standard paint — a symbol scraped or faded to half visibility is treated as a compliance gap.

Striping pairs with signage. Each stall needs a vertical sign with the accessibility symbol mounted at least 60 inches to the bottom, a "Van Accessible" plate on van stalls, and Oregon's supplemental fine-amount plate. A restripe that leaves old, low, or missing signs in place is only half finished.

Timing the Restripe in La Grande

Striping needs dry pavement and temperatures above 50°F to cure properly. At La Grande's elevation that window is shorter than in the valley — the reliable stretch is mid-to-late spring through early fall, after the freeze risk passes. Restriping right after a fresh sealcoat gives the new paint better adhesion and contrast, and hands you a blank slate to correct the entire accessible layout. Campus-adjacent lots are easiest to restripe over a school break, and booking early secures the short high-valley season.

A Practical Restripe Sequence

1. Count existing spaces and check the required accessible and van count against your total.
2. Measure existing accessible stalls and aisles for width and slope.
3. Chalk the corrected layout — stalls, aisles, hatching, symbol locations.
4. Verify the accessible route from the stalls to the entrance is continuous and marked.
5. Apply durable paint in dry, warm conditions.
6. Update or install compliant signs at the correct height with the fine plate.

For general lot striping in the area — drive aisles, fire lanes, standard stalls, curb paint — see parking lot striping in La Grande. This article covers general ADA layout guidance; an on-site measurement is the only way to confirm your specific stalls comply.